Service Manual
Version Description
E-Series Original command.
Usage Information Users entering EXEC Privilege mode or any other congured privilege level can access conguration
commands. To protect against unauthorized access, use the enable password command to congure a
password for the enable command at a specic privilege level. If no privilege level is specied, the default
is privilege level
15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related Commands enable password — congures a password for the enable command and to access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is
from 120 to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-power-
updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-power-
updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the enable xfp-power-
updates command.
Usage Information To enable polling and to congure the polling frequency, use this command.
92
Control and Monitoring