Service Manual
ip msdp default-peer
Dene a default peer from which to accept all source-active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list that contains
the RP address that should be treated as the default peer. If no access list is
specied, then all SAs from the peer are accepted.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added the list option and removed the prefix-list option.
7.4.1.0 Introduced
Usage Information If a list is not specied, all SA messages received from the default peer are accepted. You can enter multiple
default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
918
Multicast Source Discovery Protocol (MSDP)