Service Manual
Usage Information The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Dell(conf-if-gi-5/1)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-gi-5/1)#
Dell(conf-if-gi-5/1)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-gi-5/1)#
Dell(conf-if-gi-5/1)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
enable
Enter EXEC Privilege mode or any other privilege level congured. After entering this command, you may need to enter a password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of Dell Networking OS. The range
is from 0 to 15.
Defaults 15
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Control and Monitoring
91