Service Manual

Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
debug lldp interface
To display timer events, neighbor additions or deletions, and other information about incoming and outgoing packets, enable LLDP
debugging.
Syntax
debug lldp interface {interface | all}{events | packet {brief | detail} {tx
| rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events}
{packet {brief | detail} {tx | rx | both}} command.
Parameters
interface Enter the following keywords and slot/port or number information:
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
all (OPTIONAL) Enter the keyword all to display information on all interfaces.
events (OPTIONAL) Enter the keyword events to display major events such as timer
events.
packet (OPTIONAL) Enter the keyword packet to display information regarding packets
coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only packet information.
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Link Layer Discovery Protocol (LLDP)
893