Service Manual
112 0 0 00:01:e8:0d:b7:62 SYSTEM_STATIC DROP
113 0 0 00:01:e8:0d:b7:61 SYSTEM_STATIC DROP
114 0 0 00:01:e8:0d:b7:60 SYSTEM_STATIC DROP
115 0 0 00:01:e8:0d:b7:5f SYSTEM_STATIC DROP
116 0 0 00:01:e8:0d:b7:5e SYSTEM_STATIC DROP
117 0 0 00:01:e8:0d:b7:5d SYSTEM_STATIC DROP
Dell#
show mac-address-table
Display the MAC address table.
Syntax
show mac-address-table [address mac-address | interface interface | vlan
vlan-id] [aging-time] [dynamic | static] [count [vlan vlan-id] [interface
interface-type [slot [/port]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
the switch dynamically learns. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specically congured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
aging-time Enter the keyword aging-time to display only aging-time information.
interface interface (OPTIONAL) Enter the keyword interface then the interface type, slot/port
information:
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
interface interface-
type
(OPTIONAL) Instead of entering the keyword interface then the interface type,
slot/port information, as above, you can enter the interface type, then just a slot
number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC
address assigned to the VLAN. The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an interface or VLAN
ID, to display total or interface-specic static addresses, dynamic addresses, and
MAC addresses in use.
Command Modes
• EXEC
• EXEC Privilege
864
Layer 2