Service Manual

port-set port-pipe (REQUIRED) Enter the keywords port-set then a Port-Pipe number to select
the Port-Pipe for which to gather information.
count (REQUIRED) Enter the keyword count to display CAM usage by interface type.
interface interface (OPTIONAL) Enter the keyword interface then the interface type, slot and port
information:
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC
address assigned to the VLAN. The range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
pre-6.2.1.1 Introduced on the E-Series.
show cam mac linecard (dynamic or static)
Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
Syntax
show cam mac linecard slot port-set port-pipe [address mac_addr | dynamic |
interface interface | static | vlan vlan-id]
Parameters
linecard slot (REQUIRED) Enter the keyword linecard then a slot number to select the
linecard for which to gather information.
port-set port-pipe (REQUIRED) Enter the keywords port-set then a Port-Pipe number to select
the Port-Pipe for which to gather information. The range is from 0 or 1.
address mac-addr (OPTIONAL) Enter the keyword address then a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
862
Layer 2