Service Manual

To turn o debugging, use the no debug isis [vrf vrf-name]adj-packets [interface]
command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to enable the
debug information on IS-IS for an adjacency tied to that VRF. This command
displays the IIH related debug details.
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
debug isis local-updates
To debug IS-IS local update packets, enable debugging on a specic interface and provides diagnostic information.
Syntax
debug isis [vrf vrf-name] local-updates [interface]
To turn o debugging, use the no debug isis [vrf vrf—name] updates [interface]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable the
debugging information on IS-IS corresponding to that VRF. This information
contains local updates tied to the VRF that you specify. This command displays the
local LSP debugging details of the current unit.
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
790
Intermediate System to Intermediate System (IS-IS)