Service Manual
Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Usage Information
NOTE: If a route has a mask greater than 64, no output is displayed and no output is displayed for
show ipv6 cam stack-unit unit-number port-set {0-1} ipv6-address, but an
equivalent /64 entry would be listed in the show ipv6 cam stack-unit unit-number
port-set {0-1}
output. Similarly, if there is more than one ECMP object with a destination
route that has a mask greater than 64, if the rst 64 bits in the destination routes of the ECMP
objects are the same, only one route is installed in CAM even though multiple ECMP path entries
exist.
NOTE: The self address is displayed in the neighbor portion for the show ipv6 cam stack-
unit unit-number port-set command.
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
Syntax
show ipv6 control-plane icmp
Default 100
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related Commands ipv6 owlabel-zero — Congure IPv6 address auto-conguration for the management interface.
774
IPv6 Basics