Service Manual

ipv6-address (OPTIONAL) Enter the forwarding router IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
distance (OPTIONAL) Enter a number as the metric distance assigned to the route. The
range is from 1 to 255.
tag value (OPTIONAL) Enter the keyword tag then a tag value number. The range is from 1
to 4294967295.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route is not to be
removed, even if the interface assigned to that route goes down.
NOTE: If you disable the interface with an IPv6 address associated with the
keyword permanent, the route disappears from the routing table.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination
address and not for the route pointing to destination a interface.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
When the interface goes down, Dell Networking OS withdraws the route. The route is re-installed, by Dell
Networking OS, when the interface comes back up. When a recursive resolution is “broken,” Dell Networking
OS withdraws the route. The route is re-installed, by Dell Networking OS, when the recursive resolution is
satised.
After an IPv6 static route interface is created, if an IP address is not assigned to a peer interface, the peer
must be manually pinged to resolve the neighbor information.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a path is 0, then that path is
not used for forwarding when weighted ECMP is in eect. Also, if a path corresponding to a static route
(destination) has a non-zero weight assigned to it and other paths do not have any weight congured, then
regular ECMP is used for forwarding.
IPv6 Basics
771