Service Manual

Example
Dell(conf-if-gi-1/1)#ipv6 nd dns-server 1000::1 1
ipv6 nd prex
Specify which IPv6 prexes are included in Neighbor Advertisements.
Syntax
ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-advertise] |
[no-autoconfig] [no-rtr-address] [off-link] [lifetime {valid | infinite}
{preferred | infinite}]
Parameters
ipv6-prex Enter an IPv6 prex.
prex-length Enter the prex then the prex length. The length range is from 0 to 128.
default Enter the keyword default to set default parameters for all prexes.
no-advertise Enter the keyword no-advertise to prevent the specied prex from being
advertised.
no-autocong Enter the keywords no-autoconfig to disable Stateless Address
Autoconguration.
no-rtr-address Enter the keyword no-rtr-address to exclude the full router address from
router advertisements (the R bit is not set).
o-link Enter the keywords off-link to advertise the prex without stating to recipients
that the prex is either on-link or o-link.
valid-lifetime |
innite
Enter the amount of time that the prex is advertised, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
2592000. The maximum value means that the preferred lifetime does not expire
for the valid-life time parameter.
preferred-lifetime |
innite
Enter the amount of time that the prex is preferred, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
604800. The maximum value means that the preferred lifetime and does not
expire.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
IPv6 Basics
769