Service Manual
ipv6 control-plane icmp error-rate-limit
Congure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit
command.
Parameters
pps Enter the maximum number of error packets generated per second. The range is
from 1 to 200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 owlabel-zero
Congure system to set the ow label eld in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the eld and allow the protocol operations to ll the eld, use the no
ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv6 Basics
765