Service Manual

To remove the IPv6 address, use the no ipv6 address {ipv6-address prefix-length}
command.
Parameters
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x
format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.1(0.0) Updated Usage Information.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support on the management Ethernet port.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
• If two addresses are congured, delete an existing address before conguring a new address.
• If the last manually-congured global IPv6 address is removed using the “no” form of the command, the
link-local IPv6 address is removed automatically.
• IPv6 addresses on a single management interface cannot be members of the same subnet.
• IPv6 secondary addresses on management interfaces across platform must be members of the same
subnet.
• IPv6 secondary addresses on management interfaces should not match the virtual IP address and should
not be in the same subnet as the virtual IP.
Example
Dell(conf)#interface gigabitethernet 1/2
Dell(conf-if-gi-1/2)#ipv6 address ?
X:X:X:X::X IPv6 address
Dell(conf-if-gi-1/2)#ipv6 address 2002:1:2::3 ?
<0-128> Prefix length in bits
Dell(conf-if-gi-1/2)#ipv6 address 2002:1:2::3 /96 ?
<cr>
Dell(conf-if-gi-1/2)#
ipv6 address 2002:1:2::3 /96
Dell(conf-if-gi-1/2)#show config
!
interface GigabitEthernet 1/2
no ip address
IPv6 Basics
763