Service Manual

rp2 Enter the keyword rp2 to view only TCP statistics from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
6.4.1.0 Introduced
Usage Information The following describes the show tcp statistics cp command shown in the following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by the switch.
• Total = total packets received
• no port = number of packets received with no designated port
0 checksum error... Displays the number of packets received with the following:
• checksum errors
• bad oset to data
• too short
329 packets... Displays the number of packets and bytes received in sequence.
17 dup... Displays the number of duplicate packets and bytes received.
0 partially... Displays the number of partially duplicated packets and bytes received.
7 out-of-order... Displays the number of packets and bytes received out of order.
0 packets with data
after window
Displays the number of packets and bytes received that exceed the switch’s
window size.
0 packets after
close
Displays the number of packet received after the TCP connection was closed.
0 window probe
packets...
Displays the number of window probe and update packets received.
41 dup ack... Displays the number of duplicate acknowledgement packets and acknowledgement
packets with data received.
10184 ack... Displays the number of acknowledgement packets and bytes received.
Sent: Displays the total number of TCP packets sent and the number of urgent packets
sent.
748
IPv4 Routing