Service Manual

Column Heading Description
ospf 100 If routing protocols (OSPF, RIP) are congured and routes are advertised, then
information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage of
those routes. If there are no routes congured in the Dell Networking OS, this line
does not appear.
Example
Dell>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related Commands
show ip route — displays information about the routes found in the switch.
show ip trac
View IP, ICMP, UDP, TCP and ARP trac statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you
do not enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control
Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route
Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route
Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
IPv4 Routing
745