Service Manual

Field Description
Default domain... Displays the domain name (if congured).
Name/address
lookup...
States if DNS is enabled on the system.
• If DNS is enabled, the Name/Address lookup is domain service.
• If DNS is not enabled, the Name/Address lookup is static mapping
Name servers are... Lists the name servers, if congured.
Host Displays the host name assigned to the IP address.
Flags Classies the entry as one of the following:
• perm — the entry was manually congured and will not time out
• temp — the entry was learned and will time out after 72 hours of inactivity.
Also included in the ag is an indication of the validity of the route:
• ok — the entry is valid.
• ex — the entry expired.
• ?? — the entry is suspect.
TTL Displays the amount of time until the entry ages out of the cache. For dynamically
learned entries only.
Type Displays IP as the type of entry.
Address Displays the IP addresses assigned to the host.
Example
Dell#show hosts
Default domain is not set
Name/address lookup uses static mappings
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
Dell#
Related Commands
traceroute — views the DNS resolution.
ip host — congures a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} {ip-address mask
[longer-prefixes [ecmp-group detail]]}| ecmp-group {detail | member-info [detail [group-
index index-number]]}| summary]
728
IPv4 Routing