Service Manual

To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
load-balance
By default, for C-Series and S-Series, Dell Networking OS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port) to
distribute IP trac over members of a Port Channel as well as equal-cost paths. To designate another method to balance trac over
Port Channel members, use the
load-balance command.
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac |
source-dest-mac | source-mac]} | {tcp-udp | ingress-port [enable]}
To return to the default setting (IP 4-tuple), use the no load-balance {ip-selection [dest-ip
| source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-udp
| ingress-port [enable]}command.
Parameters
ip-selection {dest-ip
| source-ip}
Enter the keywords to distribute IP trac based on the following criteria:
• dest-ip — Uses destination IP address and destination port elds to hash.
The hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
• source-ip — Uses source IP address and source port elds to hash. The
hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
IPv4 Routing
719