Service Manual
Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is received, Dell Networking OS
installs an ARP entry on all three CPUs.
arp max-entries
Enables you to congure the maximum number of ARP entries per VRF that are allowed for IPv4..
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the name of a specic VRF for which you want to congure maximum
number of ARP entries that IPv4 allows.
max-number Enter the maximum number of ARP entries that a VRF RTM can hold. The range is
from 0 to 65535.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of ARP entries that the Route Table Manager can hold
for a specic VRF. This command does not apply to the management VRFs.
arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP request.
Syntax
arp retries number
Parameters
number Enter the number of retries. The range is from 1 to 20. The default is 5.
Defaults 5
Command Modes CONFIGURATION
688
IPv4 Routing