Service Manual
User Information The following describes the show interfaces port-channel brief command shown in the
following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 — for Layer 3
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not indicated.
Example
Dell#show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/1 (Up) *
Gi 3/2 (Down)
Gi 3/3 (Up)
Dell#
Related Commands
show lacp — displays the LACP matrix.
show port-channel-ow
Display an egress port in a given port-channel ow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address
{vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display ow information.
• For a Port Channel interface, enter the keywords port-channel then a
number.
The range is from 1 to 128.
incoming-interface
interface
Enter the keywords incoming-interface then the interface type and slot/
port or number information:
Interfaces
667