Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
Usage Information
This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes down, the
other LAG is taken down automatically, providing an alternate path to reroute trac, avoiding
oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to congure failover
groups. For more information, refer to the “Port Channel” chapter in the Dell Networking OS Conguration
Guide.
Related Command
group — groups two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel — displays information on congured Port Channel groups.
show cong
Display the current conguration of the selected LAG.
Syntax
show config
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Example
Dell(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
664
Interfaces