Service Manual
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP mode to congure a LAG
failover group.
show interfaces port-channel — displays information on congured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing 16 physical interfaces on the S-Series.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Interfaces
661