Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command on
the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements
must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, rst enter the switchport
command. For more information, refer to the “Conguring Redundant Links” section in the “Layer 2” chapter
of the Dell Networking OS Conguration Guide.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Congure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application conguration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
• For DNS, enter the keyword dns.
• For FTP, enter the keyword ftp.
• For NTP, enter the keyword ntp.
• For Radius, enter the keyword radius.
• For sFlow collectors, enter the keyword sflow-collector.
• For SNMP (traps and MIB responses), enter the keywords snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Congure all applications.
Defaults None.
654
Interfaces