Service Manual

NOTE: Remove all other congurations on the port before you can remove the hybrid
conguration from the port.
Example
Dell(conf)#interface gigabitethernet 7/1
Dell(conf-if-gi-7/0)#portmode hybrid
Dell(conf-if-gi-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged gigabitethernet 7/1
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged gigabitethernet 7/1
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: GigabitEthernet 7/1
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged gigabitethernet 7/1
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged gigabitethernet 7/1
Dell(conf-if-vl-20)#interface gigabitethernet 7/1
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
rate-interval
Congure the trac sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5
to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the
entered value. For example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
626
Interfaces