Service Manual

interface vlan
Congure a VLAN. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to
the specied OpenFlow instance. The range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is
created. An existing VLAN cannot be associated with an OpenFlow
instance.
Defaults Not congured, except for the Default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to congure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP
ACLs are supported. For more information, refer to the Access Control Lists (ACL) chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are congured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
Range)
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related Commands
interface — congures a physical interface.
interface loopback — congures a loopback interface.
Interfaces
617