Service Manual

define interface-range test gigabitethernet 1/1 -3, gigabitethernet 5/1
-47,
gigabitethernet 13/1 - 89
Dell(config)#interface range macro test
Dell(config-if-range-gi-1/1-3,gi-5/1-47,gi-13/1-89)#
Related Commands
interface range – congures a range of command (bulk conguration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically congure the pre-dened range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced
Example (Single
Range)
This example shows the macro named test that was dened earlier.
Dell(config)#interface range macro test
Dell(config-if-range-gi-1/1-3,gi-5/1-47,gi-13/1-89)#
Dell
Related Commands
interface range — congures a range of command (bulk conguration).
interface range macro (dene) — denes a macro for an interface range (bulk conguration).
616
Interfaces