Service Manual
Related Commands
show running-cong — displays the ow conguration parameters (non-default values only).
show interfaces — displays the negotiated ow control parameters.
interface
Congure a physical interface on the switch.
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a null interface, enter the keyword null then the slot/port information.
The Null interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
1 to 11. The port range is 1.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
range (Optional) Enter the keyword range to congure an interface range.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
Interfaces
607