Service Manual
std-access-list Specify the standard IP access list that contains the mapping rules for multicast
groups.
source-address Specify the multicast source address to which the groups are mapped.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reected in the IGMP groups.
You may not use extended access lists with this command. When you congure a static SSM map and the
router cannot nd any matching access lists, the router continues to accept (*,G) groups.
Related Commands ip access-list standard — creates a standard access list to lter based on IP address.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Defaults 2 (that is, IGMPv2)
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
584
Internet Group Management Protocol (IGMP)