Service Manual
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage Information
• Join Timer — Join messages announce the willingness to register some attributes with other
participants. For reliability, each GARP application entity sends a Join message twice and uses a join
timer to set the sending interval.
• Leave Timer — Leave announces the willingness to de-register with other participants. Together with
Join, Leave messages help GARP participants complete attribute reregistration and de-registration.
The leave timer starts after receipt of a leave message sent for de-registering some attribute
information. If a Join message is not received before the Leave time expires, the GARP application
entity removes the attribute information as requested.
• Leave All Timer — The Leave All timer starts when a GARP application entity starts. When this timer
expires, the entity sends a Leave-all message so that other entities can reregister their attribute
information. Then the Leave-all time begins again.
Related Commands show garp timers — displays the current GARP times.
gvrp enable
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command Modes CONFIGURATION-INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
556
GARP VLAN Registration (GVRP)