Service Manual

To disable debugging, use the no debug gvrp {config | events | pdu} command.
Parameters
cong Enter the keyword config to enable debugging on the GVRP conguration.
event Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu then one of the following Interface keywords and slot/port
or number information:
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Disabled.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
554
GARP VLAN Registration (GVRP)