Manualshelf

Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
51525354555657585960
2. Enter the ipv6 router ospf {process-id} command. The prompt changes to include (conf-ipv6-router_ospf).
You can return to CONFIGURATION mode by using the exit command.
ROUTER RIP Mode
To enable and congure Router Information Protocol (RIP), use ROUTER RIP mode. For more information, refer to Routing
Information Protocol (RIP).
To enter ROUTER RIP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router rip command. The prompt changes to include (conf-router_rip).
You can return to CONFIGURATION mode by using the exit command.
SPANNING TREE Mode
To enable and congure the Spanning Tree protocol, use SPANNING TREE mode. For more information, refer to Spanning Tree
Protocol (STP).
To enter SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree stp-id command. The prompt changes to include (conf-stp).
You can return to CONFIGURATION mode by using the exit command.
TRACE-LIST Mode
To congure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to include (conf-trace-acl).
You can exit this mode by using the exit command.
VLT DOMAIN Mode
To enable and congure the VLT domain protocol, use VLT DOMAIN mode. For more information, refer to Virtual Link Trunking (VLT).
To enter VLT DOMAIN mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the vlt domaincommand then the VLT domain number. The prompt changes to include (conf-vlt-domain).
You can return to CONFIGURATION mode by entering the exit command.
VRRP Mode
To enable and congure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, refer to Virtual Router
Redundancy Protocol (VRRP).
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include (conf-if-interface-type-slot/
port-vrid-vrrp-group-id).
CLI Basics
53