Service Manual
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information Use this command to add domain names to the DNS lists corresponding to a specic VRF. You can add up
to a maximum of six domain names to the DNS list corresponding to a VRF. This domain is used to complete
the unqualied host names.
Example
Dell(conf)#ip domain-list vrf jay dell.com
Dell(conf)#ip domain-list vrf jay force10.com
ip host
Congures a mapping between the host name server and the IP address for a specic VRF. This mapping information is used by the
name-to-IP address table to resolve host names.
Syntax
ip host [vrf vrf-name] name ip-address
To undo the host name server to IP address mapping for VRFs, use the no ip host [vrf vrf-name]
name ip-address command.
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the VRF to congure the
name server to IP address mapping for that VRF.
name Enter the name od the host to be associated with an IP address.
ip-address Enter the IP address of the name server in dotted decimal format.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information Use this command to create a mapping between a host name server and its IP addresses for a specic VRF.
Example
Dell(conf)#ip host vrf jay dell 1.1.1.1
524
Dynamic Host Conguration Protocol (DHCP)