Manualshelf

Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
51525354555657585960
To enter OPENFLOW INSTANCE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the openflow of-instance command then the OpenFlow ID number of the instance you want to create or
congure. The prompt changes to include (conf-of-instance
of-id).
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE (PVST+) Plus Mode
To enable and congure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, refer to Per-VLAN
Spanning Tree Plus (PVST+).
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-pvst).
You can return to CONFIGURATION mode by using the exit command.
PORT-CHANNEL FAILOVER-GROUP Mode
To congure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, refer to Port
Channel Commands.
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the port-channel failover-group command. The prompt changes to include (conf-po-failover-grp).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To congure a prex list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip prefix-list command. Include a name for the prex list. The prompt changes to include (conf-nprexl).
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and congure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, refer to
GARP VLAN Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol gvrp command. The prompt changes to include (cong-gvrp).
You can return to CONFIGURATION mode by using the exit command.
RAPID SPANNING TREE (RSTP) Mode
To enable and congure RSTP, use RSTP mode. For more information, refer to Rapid Spanning Tree Protocol (RSTP).
To enter RSTP mode:
CLI Basics
51