Service Manual
Version Description
9.2.(0.0) Introduced on the S4810 and S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series on Layer 2 interfaces.
7.8.1.0 Introduced on the C-Series and S-Series on Layer 3 interfaces.
Usage Information
When enabled, no learning takes place until you enable snooping on a VLAN. After disabling DHCP snooping,
the binding table deletes and Option 82, IP Source Guard, and Dynamic ARP Inspection are disabled.
Introduced in Dell Networking OS version 7.8.1.0, DHCP snooping was available for Layer 3 only and
dependent on DHCP Relay Agent (ip helper-address). Dell Networking OS version 8.2.1.0 extends
DHCP Snooping to Layer 2. You do not have to enable relay agent to snoop on Layer 2 interfaces.
ipv6 dhcp snooping
Enable DHCPv6 snooping globally for ipv6.
Syntax
[no] ipv6 dhcp snooping
To disable the snooping globally, use the no ipv6 dhcp snooping command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
ipv6 dhcp snooping vlan
Enable ipv6 DHCP Snooping on VLAN or range of VLANs.
Syntax
[no] ip dhcp snooping vlan vlan-id
To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no ipv6 dhcp snooping
vlan <vlan-id> command.
Parameters
vlan-id Enter the name of a VLAN id or list of the VLANs to enable DHCP Snooping.
Defaults Disabled
Command Modes CONFIGURATION
Dynamic Host Conguration Protocol (DHCP)
509