Service Manual

2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-interface-lldp).

LLDP MANAGEMENT INTERFACE Mode

To enable and congure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT INTERFACE

mode.

To enter LLDP MANAGEMENT INTERFACE mode:

1. Verify that you are logged in to LLDP mode.

2. Enter the management-interface command. The prompt changes to include (conf-lldp-mgmtIf).

LINE Mode

To congure the console or virtual terminal parameters, use LINE mode.

To enter LINE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the line command. Include the keywords console or vty and their line number available on the switch. The prompt

changes to include (cong-line-console) or (cong-line-vty).

You can exit this mode by using the exit command.

MAC ACCESS LIST Mode

To enter MAC ACCESS LIST mode and congure either standard or extended access control lists (ACLs), use the mac access-

list standard or mac access-list extended command.

To enter MAC ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the mac access-list standard or mac access-list extended command. Include a name for the ACL. The

prompt changes to include (conf-std-macl) or (conf-ext-macl).

You can return to CONFIGURATION mode by using the exit command.

MONITOR SESSION Mode

To enable and congure a trac monitoring session using port monitoring, use MONITOR SESSION mode. For more information,

refer to Port Monitoring.

To enter MONITOR SESSION mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the monitor session command then the session ID. The prompt changes to include (conf-mon-sess-sessionID).

MULTIPLE SPANNING TREE (MSTP) Mode

To enable and congure MSTP, use MULTIPLE SPANNING TREE mode. For more information, refer to Multiple Spanning Tree

Protocol (MSTP).

To enter MULTIPLE SPANNING TREE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree mstp command. The prompt changes to include (conf-mstp).

You can return to CONFIGURATION mode by using the exit command.

OPENFLOW INSTANCE Mode

To enable and congure OpenFlow instances, use OPENFLOW INSTANCE mode.

CLI Basics