Service Manual

Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced this command.
hardware watchdog
To trigger a reboot and restart the system, set the watchdog timer.
Syntax
hardware watchdog stack-unit {<0-5> | all}
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage Information This command enables a hardware watchdog mechanism that automatically reboots an Dell Networking OS
switch/ router with a single unresponsive unit. This behavior is a last-resort mechanism intended to prevent
a manual power cycle.
show hardware layer2
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set 0–0
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select between
ingress or egress ACL data.
stack-unit id Enter the keyword stack-unit to select a stack ID. The range is from 1 to 6.
Debugging and Diagnostics
471