Service Manual
verbose Enter the keyword verbose to run the diagnostic in Verbose mode. Verbose
mode gives more information in the output than Standard mode.
testname Enter the keyword testname to run a specic test case. Enclose the test case
name in double quotes (“ “). For example: diag stack-unit 1 level1
testname “first”
. You can use this option only for interactive tests.
no-reboot Enter the keyword no-reboot to prevent the system from rebooting after the
test. To bring the stack unit to online state, use the online stack-unit
command.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the verbose option.
7.7.1.0 Introduced on the S-Series.
oine stack-unit
Place a stack unit in the oine state.
Syntax
offline stack-unit number
Parameters
number
Enter the stack-unit id.
The range is from 1 to 6.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
Debugging and Diagnostics
467