Service Manual

peer-group name Clear and reapply policies for all BGP routers in the specied peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series TeraScale.
debug ip bgp ipv6 unicast soft-reconguration
Enable soft-reconguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor on which you want to enable soft-
reconguration debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-
reconguration debugging.
ipv6 unicast Debug soft reconguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Border Gateway Protocol
445