Service Manual

When a combination of locally originated and peer originated routes occurs, both these routes will exist in
the RTM. However, only the best route is kept active in the RTM and the remaining route is rendered in-
active.
It is possible to keep only one locally originated route in the BGP database. Network command has
preference over the re-distributed routes. When the locally originated route is no longer present in the
database the other route is automatically installed.
Related Commands neighbor default-originate — injects the default route.
redistribute ospf
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]]
[route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
process-id Enter the number of the OSPF process. The range is from 1 to 65535.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF
external routes. You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a congured
route map.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/peer-group
outbound route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
402
Border Gateway Protocol