Service Manual

show ip bgp neighbors — displays the current BGP neighbors.
neighbor soft-reconguration inbound
Enable soft-reconguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer
group.
Defaults Disabled
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information
This command enables soft-reconguration for the BGP neighbor specied. BGP stores all the updates the
neighbor receives but does not reset the peer-session.
You cannot set this conguration for a peer that is associated with a peer group. Similarly, you cannot
associate a peer to a peer group if that peer is already congured with these settings.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results applied on
the neighbor.
NOTE: This command is supported in BGP Router Conguration mode for IPv4 Unicast address
only.
394
Border Gateway Protocol