Service Manual

bgp client-to-client reection
Allows you to enable route reection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reection, use the no bgp client-to-client reflection command.
Defaults Enabled when a route reector is congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information Route reection to clients is not necessary if all client routers are fully meshed.
Related Commands
bgp cluster-id — assigns an ID to a BGP cluster with two or more route reectors.
neighbor route-reector-client — congures a route reector and clients.
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reector.
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number} command.
Parameters
ip-address Enter an IP address as the route reector cluster ID.
number Enter a route reector cluster ID as a number from 1 to 4294967295.
Defaults Not congured.
Command Modes ROUTER BGP
344
Border Gateway Protocol