Service Manual

Field Description
VlanOpenFlow Number of FP blocks for VLAN open ow
operations.
VlanIscsi Number of FP blocks for VLAN internet small
computer system interface (iSCSI) counters.
VlanHp Number of FP blocks for VLAN high performance
processes.
VlanFcoe Number of FP blocks for VLAN Fiber Channel over
Ethernet (FCoE) operations.
VlanAclOpt Number of FP blocks for ACL VLAN optimzation
feature.
Example
Dell#show cam-acl-vlan
-- Chassis Vlan Cam ACL --
Current Settings(in block sizes)
VlanOpenFlow : 0
VlanIscsi : 0
VlanAclOpt : 2
VlanHp : 1
VlanFcoe : 1
cam-acl-vlan
Allocate the number of ow processor (FP) blocks or entries for VLAN services and processes.
Syntax
cam-acl-vlan { default | vlanopenflow <0-2> | vlaniscsi <0-2> | vlanaclopt
<0-2>
Parameters
default Reset the number of FP blocks to default. By default, 0 groups are allocated for the
ACL in VCAP. ACL VLAN groups or CAM optimization is not enabled by default,
and you need to allocate the slices for CAM optimization.
vlanopenow <0-2>
Allocate the number of FP blocks for VLAN open ow operations.
vlaniscsi <0-2> Allocate the number of FP blocks for VLAN iSCSI counters.
vlanaclopt <0-2> Allocate the number of FP blocks for the ACL VLAN optimization feature.
Default If you use the default keyword with the cam-acl-vlan command, the FP blocks allocated for VLAN
processes are restored to their default values. No FP blocks or dynamic VLAN Content Aware Processor
(VCAP) groups are allocated for VLAN operations by default.
Command Modes CONFIGURATION
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.3(0.0) Introduced on the S4810 and Z9000 platforms.
314
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)