Service Manual

Parameters
weight Enter a number as the weight used by the route meeting the route map
specication. The range is from 0 to 65535. The default is router-originated =
32768 and all other routes = 0.
When there are multiple routes to the same destination, the routes with a higher
weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information If you do not use the set weight command, router-originated paths have a weight attribute of 32768 and
all other paths have a weight attribute of zero.
show cong
Display the current route map conguration.
Syntax
show config
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
266
Access Control Lists (ACL)