Service Manual

Version Description
pre-6.1.1.0 Introduced on the E-Series.
set tag
To specify a tag for redistributed routes, congure a lter.
Syntax
set tag tag-value
To delete a setting, use the no set tag command.
Parameters
tag-value Enter a number as the tag. The range is from zero (0) to 4294967295.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
set automatic-tag — computes the tag value of the route.
set level — species the OSPF area for route redistribution.
set metric — species the metric value assigned to redistributed routes.
set metric-type — species the route type assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, congure a lter.
Syntax
set weight weight
To delete a weight specication, use the no set weight weight command.
Access Control Lists (ACL)
265