Service Manual

show ip prex-list summary
Display a summary of the congured prex lists.
Syntax
show ip prefix-list summary [prefix-name]
Parameters
prex-name (OPTIONAL) Enter a text string as the name of the prex list, up to 140 characters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell#show ip prefix-list summary
Ip Prefix-list with the last deletion/insertion: PL_OSPF_to_RIP
ip prefix-list PL_OSPF_to_RIP:
count: 3, range entries: 1, sequences: 5 - 25
Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior reects implicit permit.
To congure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, congure a route-map.
Syntax
continue [sequence-number]
Access Control Lists (ACL)
243