Service Manual
NOTE: For more information, refer to the Flow-based Monitoring section in
the Port Monitoring chapter of the
Dell Networking OS Conguration
Guide
.
Defaults Not congured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage Information
When you use the log option, the CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
NOTE: When you congure the ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Congure packet counters with logging instead.
Related Commands
deny — congures a MAC ACL lter to drop packets.
seq — congure a MAC ACL lter with a specied sequence number.
IP Prex List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior reects implicit permit.
To congure or enable IP prex lists, use these commands.
Access Control Lists (ACL)
237