Service Manual

NOTE: For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Conguration
Guide .
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter. Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage Information
When you use the log option, the CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
NOTE: When you congure the ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Congure packet counters with logging instead.
Related Commands
deny — congures a lter to drop packets.
permit — congures a lter to forward packets.
Extended MAC ACL Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reects implicit permit. The following
commands congure Extended MAC ACLs.
The platform supports both Ingress and Egress MAC ACLs.
232
Access Control Lists (ACL)