Service Manual
NOTE:
1. If the MAC ACL is applied on VLAN, none of the VLAN members should have an access list applied
for that VLAN.
2. If the MAC ACL is applied on a Physical or Port Channel interface, the VLAN in which this port is
associated should not have an access list applied.
3. If the MAC ACL is applied on a VLAN, then that VLAN should not belong to VLAN ACL group.
4. If the MAC ACL is applied on a VLAN ACL group, then none of the VLANs in that group should have
an access list applied on it.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information You can assign one ACL (standard or extended) to an interface.
Related Commands
mac access-list standard — congures a standard MAC ACL.
mac access-list extended — congures an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs congured in the system, whether or not they are applied to an interface, and the count of matches/
mismatches against each ACL entry displayed.
Syntax
show mac access-lists [access-list-name] [interface interface] [in | out]
Parameters
access-list-name Enter the name of a congured MAC ACL, up to 140 characters.
Access Control Lists (ACL)
225