Service Manual

dot1x max-eap-req
Congure the maximum number of times an extensive authentication protocol (EAP) request is transmitted before the session times
out.
Syntax
dot1x max-eap-req number
To return to the default, use the no dot1x max-eap-req command.
Parameters
number Enter the number of times an EAP request is transmitted before a session time-
out. The range is from 1 to 10. The default is 2.
Defaults 2
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
dot1x max-supplicants
Restrict the number of supplicants that can be authenticated and permitted to access the network through the port. This
conguration is only takes eect in Multi-auth mode.
Syntax
dot1x max-supplicants number
Parameters
number Enter the number of supplicants that can be authenticated on a single port in
Multi-auth mode. The range is from 1 to 128. The default is 128.
Defaults 128 hosts can be authenticated on a single authenticator port.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
802.1X
179