Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced support for telnetting to the VRRP group IP address assigned using this
command.
6.2.1.1 Introduced on the E-Series.
Usage Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is congured.
When you delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, congure the VRRP group’s virtual address with the
same IP address as the interface’s primary IP address and change the priority of the VRRP group to 255.
You can ping the virtual addresses congured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP initialization after an interface
becomes operational. The range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
1530
Virtual Router Redundancy Protocol (VRRP)