Service Manual
64
Virtual Router Redundancy Protocol (VRRP)
Virtual router redundancy protocol (VRRP) is supported by the Dell Networking operating system on Dell Networking OS.
IPv4 VRRP Commands
The following are IPv4 VRRP commands.
advertise-interval
Set the time interval between VRRP advertisements.
Syntax
advertise-interval {seconds | centisecs centisecs }
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is from 1 to 255. The default is 1 second.
centisecs centisecs Enter the keyword centisecs followed by the number of centisecs in multiple of
25 centisecs. The range is 25 to 4075 centisecs in multiples of 25 centisecs.
Defaults 1 second or 100 centisecs.
Command Modes INTERFACE-VRRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for centisecs on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
1518
Virtual Router Redundancy Protocol (VRRP)