Service Manual

vlt domain
Enable VLT on a switch, congure a VLT domain, and enter VLT-domain conguration mode.
Syntax
vlt domain domain-id
Parameters
domain-id Enter the Domain ID number. Congure the same domain ID on the peer switch.
The range of domain IDs is from 1 to 1000.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same, a
syslog message is generated and VLT does not launch.
Related Commands show vlt — uses the show vlt brief command to display the delay-restore value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective vlt port-channel number of the peer device. The range is from
1 to 128.
Defaults Not congured.
Command Modes INTERFACE PORT-CHANNEL
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1516
Virtual Link Trunking (VLT)